Note: You are reading this message either because you can not see our css files, or because you do not have a standards-compliant browser.

LOGO: Journal of Cotton Science


Combined Lint Cleaning System Particulate Emission Factors for Cotton Gins: Particle Size Distribution Characteristics

Authors: Michael D. Buser, Derek P. Whitelock, J. Clif Boykin, and Gregory A. Holt
Pages: 453-464
Engineering and Ginning

This report is part of a project to characterize cotton gin emissions from the standpoint of total particulate stack sampling and particle size analyses. In 2006 and again in 2013, the United States (U.S.) Environmental Protection Agency (EPA) published a more stringent National Ambient Air Quality Standard for particulate matter with nominal diameter less than or equal to 2.5 µm (PM2.5). This created an urgent need to collect additional cotton gin emissions data to address current regulatory issues, because EPA AP-42 cotton gin PM2.5 emission factors were limited. In addition, current EPA AP-42 emission factor quality ratings for cotton gin PM10 (particulate matter with nominal diameter less than or equal to 10 µm) data are questionable, being extremely low. The objective of this study was to characterize particulate emissions for combined lint cleaning systems from cotton gins across the cotton belt based on particle size distribution analysis of total particulate samples from EPA-approved stack sampling methods. Average measured PM2.5, PM6, and PM10 emission factors based on the mass and particle size analyses of EPA Method 17 total particulate filter and wash samples from three gins (9 total test runs) were 0.0032 kg/227-kg bale (0.0070 lb/500-lb bale), 0.032 kg/bale (0.071 lb/bale), and 0.060 kg/bale (0.131 lb/bale), respectively. The combined lint cleaning system particle size distributions were characterized by an average mass median diameter of 19.9 µm (aerodynamic equivalent diameter). Based on system average emission factors, the ratio of PM2.5 to total particulate was 1.50%, PM6 to total particulate was 15.3%, and PM10 to total particulate was 28.2%.