Note: You are reading this message either because you can not see our css files, or because you do not have a standards-compliant browser.

LOGO: Journal of Cotton Science

 

Combined Mote System PM10 Emission Factors and Rates for Cotton Gins: Hope Method 201A PM10 Sizing Cyclones

Authors: Derek P. Whitelock, Michael D. Buser, J. Clif Boykin, and Gregory A. Holt
Pages: 300-308
Engineering and Ginning

This report is part of a project to characterize cotton gin emissions from the standpoint of stack sampling. The impetus behind this project was the urgent need to collect additional cotton gin emissions data to address current regulatory issues. A key component of this study was focused on EPA emission factors for particulate matter with a particle diameter nominally less than or equal to 10 µm (PM10). The 1996 EPA AP-42 emission factors were assigned quality ratings, from A (Excellent) to E (Poor), to assess the quality of the data being referenced. Emission factor quality ratings for cotton gins were extremely low. Cotton gin data received these low ratings because they were collected almost exclusively from a single geographical region. The objective of this study was to collect additional PM10 emission factor data for combined mote systems at cotton gins located in regions across the cotton belt based on EPA-approved stack sampling methodology, Method 201A. The project plan included sampling seven cotton gins across the cotton belt. Key factors for selecting specific cotton gins included: 1) facility location, 2) production capacity, 3) processing systems, and 4) abatement technologies. Two of the seven gins were equipped with combined mote systems where the 1st and 2nd stage mote system exhaust airstreams were combined. In terms of capacity, the two gins were typical of the industry, averaging 35.1 bales/h during testing. The combined mote system average emission factors for PM10 and total particulate were 0.098 kg/227-kg bale (0.215 lb/500-lb bale) and 0.141 kg/bale (0.310 lb/bale), respectively. System average PM10 and total particulate emission factors were higher than those currently published in EPA AP-42. The combined mote system PM10 emission rate test averages ranged from 2.57 to 4.28 kg/h (5.66-9.44 lb/h). The ratio of combined mote system PM10 to total particulate was 69.3%.